1. Install 2 x “AAA” batteries
2. Open your Vera Controller website (http://home.getvera.com)
3. From the Dashboard screen select “Devices” on the left navigation
4. Select “Add Device” from the right side of the screen
5. Select “Hand Held” from the list, and "Scene Controller - Remotec ZRC-90"
6. Click “Next” and “Next” again to put the controller in learning mode
7. On the back of the ZRC-90 press the “L” setup button*
8. The controller will now recognise the device and the screen will change to ‘Device Detected’
a. Enter the name you want to refer to the device by
b. Enter the room that the device will be associated with
9. Click “Finish”
*NOTE: The batteries pop out easily when the cover is removed. Be careful to use your finger and hold the batteries in place while you are joining the device to the network. If the device loses power during the setup it could need resetting.
2. Open your Vera Controller website (http://home.getvera.com)
3. From the Dashboard screen select “Devices” on the left navigation
4. Select “Add Device” from the right side of the screen
5. Select “Hand Held” from the list, and "Scene Controller - Remotec ZRC-90"
6. Click “Next” and “Next” again to put the controller in learning mode
7. On the back of the ZRC-90 press the “L” setup button*
8. The controller will now recognise the device and the screen will change to ‘Device Detected’
a. Enter the name you want to refer to the device by
b. Enter the room that the device will be associated with
9. Click “Finish”
*NOTE: The batteries pop out easily when the cover is removed. Be careful to use your finger and hold the batteries in place while you are joining the device to the network. If the device loses power during the setup it could need resetting.